MP40 issue

[ID-Reefer]

I have four MP40s. 3 new and an older one. All are QD. Unfortunately this older one fell and hit the floor before I put on the zip tie sticker. It did work for about a month without problems. Then all the sudden it stopped. Now it tries to start but it hen gives up. Over and over. I’ve cleaned it. Tried several times turning it off repositioning and just does the same. Tries to start then Blinking light. Won’t start.

so is this thing toast? Thanks in advance for any opinions or possible remedies.

 

[sas226]

Can buy a new driver for some change directly from ecotech, It's still pricey.. 200 I think? but better than 400.

MP40QD Dryside

MP40 QuietDrive Dry Side Only. Spacers and gaskets are sold separately.Not compatible with EcoSmart or legacy MP40 controllers. Disassembly video

store2.ecotechmarine.com

 

[Reef Tripp]

Uncover the pump and check for any piece of plastic that is braking, or even if a bearing is braking, I don't think you need to change the entire motor if the Bearings are in case. Sure as long as it's out of warranty

 

[ID-Reefer]

Uncover the pump and check for any piece of plastic that is braking, or even if a bearing is braking, I don't think you need to change the entire motor if the Bearings are in case. Sure as long as it's out of warranty

Well i finally took the time to take it apart. As you mentioned there was some broken plastic inside. Both front and back. Bearings were fine. Put back together and she runs great. Glad I didn’t toss it or give away.