MP40 manual programming

[Mikeltee]

I had to get a new Control board for my mp40 so I deleted my wXM module to get a fresh start. The apex program is not working right. I'm a software engineer and prefer to code it anyways. This is how I did it for 10 years before fusion came out. Unfortunately I lost my notes.

Cam someone please post a snippet of the code you are running with at least 2 different modes? Also, I want anti-sync on the slave correct? Do I code it 100% on the slave to get 100% of whatever the master is running.

Ex:
Vortech-Left- reefcrest 80%
Virtech-Right- anti-sync 100% (which equates to 80% correct).

 

[Joe31415]

Virtech-Right- anti-sync 100% (which equates to 80% correct).

I can't answer your Apex question, but this is correct. The slave percentage is the percentage of the master. So if the left is 80% and the right is 100%, they're both 80%. Similarly, if the left is 80% and the right is 50%, they'll be running at 80% and 40%.
IIRC, that wasn't well explained in the directions, but when you have them both set to, say, 50%, it's obvious that one is running a lot slower than the other.