MP40 Mobius error
- Thread starter CWalters
- Start date
- Tagged users None
Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)
Did you factory reset the driver?
CWalters
Active Member
I held down mode and set until it flashed red white and blue, then mode until purple and red, and then power button until it reset.
Something else I need to do?
Try closing the app completely, power cycle the vortech and then try to push the update
CWalters
Active Member
Tried that. Tried turning on airplane mode as well. Super weird because when this chip was in my Vectra it works just fine
Ypu have it attached to mabius, so it's doubtful that the rf chip is the problem.
You're experiencing update issues.
Do you have an mxm connected to that mobius tank too?
You're experiencing update issues.
Do you have an mxm connected to that mobius tank too?
Try going to SETTINGS > TROUBLESHOOTING > VERIFY SETTINGS.
See what's corrupted with that VT
See what's corrupted with that VT
CWalters
Active Member
Nothing will show up there though, I cannot get the MP40 to show in there.
Does it show up in DEVICES?
Oh! My mistake, I thought you were beyond that.
That red icon on the top right indicates that the factory reset didn't take....
Can you do it again?
support.ecotechmarine.com
That red icon on the top right indicates that the factory reset didn't take....
Can you do it again?
VorTech Propeller Pump Controller Reset
Overview EcoSmart and QuietDrive VorTech Controllers have 2 different resets available to you. To perform a soft or hard Reset, see their descriptions and instructions below.Soft Reset: Clears the...
CWalters
Active Member
Tried reseting again and its still thereOh! My mistake, I thought you were beyond that.
That red icon on the top right indicates that the factory reset didn't take....
Can you do it again?
VorTech Propeller Pump Controller Reset
Overview EcoSmart and QuietDrive VorTech Controllers have 2 different resets available to you. To perform a soft or hard Reset, see their descriptions and instructions below.Soft Reset: Clears the...
I'm only speculating here, I wonder if there's a conflict with that rf coming from a vectra.
I'm at a loss as well... you'll have to reach out to ecotech cs.
Completely closing the app or better yet restarting the phone/device, then factory reset the driver should've worked.
I'm at a loss as well... you'll have to reach out to ecotech cs.
Completely closing the app or better yet restarting the phone/device, then factory reset the driver should've worked.
CWalters
Active Member
Yea.. as soon as I thought about the vectra still showing up on Mobius without the chip, I deleted it. So not 100% sure what else...
Another long shot is to put the chip back in the vectra, go through the motions to remove it from mobius. And then factory reset the vectra.
Then put the rf chip in the vortech and see if that makes a difference?
CWalters
Active Member
Nothing… thanks for the help. I will contact mobius Monday
Please reply back to let me know what the solution is
CWalters
Active Member
Will do. Going to pull a chip from one of my xr30s. See if it’ll update then swap it back.
