Multiple Vortechs on a single power supply?
- Thread starter ReefinIt
- Start date
- Tagged users None
DanyL
Valuable Member
from the spec they are 37W each, and from what I remember (and you need to verify this, because I can’t get to my PSU easily to check myself) they are running off 32v.
I recommend getting a Meanwell HLG-150H-36, this is a high grade 150W @ 36v PSU which you can adjust down to 32v and will be enough to power all 3 pumps.
I recommend getting a Meanwell HLG-150H-36, this is a high grade 150W @ 36v PSU which you can adjust down to 32v and will be enough to power all 3 pumps.
DanyL
Valuable Member
If you look at your current PSU you’ll see the voltage the pumps are operating in, as well as their consumption in amperes.
Wattage equals voltage times ampere.
Once you know the exact consumption times the amount of pumps (3), it is recommended to add another 10-20 percent on top of it.
From looking at the spec on Ecotech’s site, the pumps consume 37W each, if the voltage is 32 like I remember than it equals to 111W@32v and the PSU I recommended should be well enough to handle them all.
But note that you’ll have to adjust the PSU accordingly to provide the correct voltage. Easiest way to go about this is to take a multimeter and measure the voltage while adjusting the screw.
Wattage equals voltage times ampere.
Once you know the exact consumption times the amount of pumps (3), it is recommended to add another 10-20 percent on top of it.
From looking at the spec on Ecotech’s site, the pumps consume 37W each, if the voltage is 32 like I remember than it equals to 111W@32v and the PSU I recommended should be well enough to handle them all.
But note that you’ll have to adjust the PSU accordingly to provide the correct voltage. Easiest way to go about this is to take a multimeter and measure the voltage while adjusting the screw.
