Need Apex FMM Help

[Sean.Bozeman]

I pulled my sump and gear out from under my aquarium to clean it all up. When I reconnected my Flo monitors back to my FMM they didn’t show up in Fusion and I don’t know how to get them back. Any help would be greatly appreciated.

 

[COreef8]

You may have checked this already but if you click that lock icon on the top right corner of the main dashboard, there is a list of unused parameters and sensors. If you disconnect something, it will disappear from your dashboard and when you reconnect it, it will drop into that horizontal list.

If not, double check that the FMM module ports are set to the correct sensor by opening the modules page then clicking on the fmm. I think it defaults to auto detect but sometimes it applies the wrong type of sensor. It makes it hard to find your flow sensor if it’s listed in there as a leak detector, and that’s happened to me before.

 

[lakai]

unplug the fmm and plug it in again.

 

[Sean.Bozeman]

Thanks...I got it fixed yesterday.