mystichrome
New Member
Okay, first post here - normally post on NanoReef but frequently on here as well.
I have an IM20 Peninsula. I'm adding a 2nd AI prime to my tank but since there are no mounting brackets made for 2 lights I'm trying to make my own.
I'm TRYING to keep this as clean as possible obviously, and also trying to avoid mounting to the wall because I don't like that look at all.
This is what I came up with using an AI rigid mount and an aluminum plate - problem I've run into so far is that the aluminum plate is too malleable and bends when I place the AI prime at the far end (not physically attached to it yet) but I just placed it on top of the plate and it bends 3-4 inches downwards.
I have a few things bothering me
1) I COULD buy a piece of wood instead like a 1X3X(lenght of arm) and use that which I think will not bend with the weight of the light - BUT, will that be TOO much weight on the back glass of my IM with the AI piece mounted there?
2) If I switch to a stainless steel plate - It shouldnt bend as much right? And if so, then weight is a concern for me again, and also how do I even cut steel at home with basic tools.
3) Any way I can reinforce the aluminum the way it is now?
Open to any suggestions? Not in a rush to do this but just want to do it right and as clean as possible.
Thanks in advance!
I have an IM20 Peninsula. I'm adding a 2nd AI prime to my tank but since there are no mounting brackets made for 2 lights I'm trying to make my own.
I'm TRYING to keep this as clean as possible obviously, and also trying to avoid mounting to the wall because I don't like that look at all.
This is what I came up with using an AI rigid mount and an aluminum plate - problem I've run into so far is that the aluminum plate is too malleable and bends when I place the AI prime at the far end (not physically attached to it yet) but I just placed it on top of the plate and it bends 3-4 inches downwards.
I have a few things bothering me
1) I COULD buy a piece of wood instead like a 1X3X(lenght of arm) and use that which I think will not bend with the weight of the light - BUT, will that be TOO much weight on the back glass of my IM with the AI piece mounted there?
2) If I switch to a stainless steel plate - It shouldnt bend as much right? And if so, then weight is a concern for me again, and also how do I even cut steel at home with basic tools.
3) Any way I can reinforce the aluminum the way it is now?
Open to any suggestions? Not in a rush to do this but just want to do it right and as clean as possible.
Thanks in advance!
