Neo-Therm Awesome when they work... Not So Much When They Don't

  • Thread starter Thread starter DWill
  • Start date Start date
  • Tagged users None

DWill

Active Member
View Badges
Joined
Jan 11, 2020
Messages
444
Reaction score
375
Rating - 0%
0   0   0
Wondering if anyone else has seen what I'm about to describe and if so is my Neo-Therm toast...

I have a 100W Neo-Therm that's about 4 months old. It's been running pretty much flawlessly since I put it in and turned it on.
It was on an Ink Bird and I had it set to control the temp because it kept the temp withing on a half degree, much better than the Ink Bird.

The problem is when the water temp gets below the set point the controller (see below) will turn the power on to the Neo-Therm. The controller is set at 78 (-.6 to turn on the heat), the Neo-Therm is set to 80.

Randomly the Neo-Therm will not come on and the temp will drop below the setpoint and heating differential.
When the Neo-Therm fails to turn on I can unplug it, wait a few seconds, plug it back in and it works again... until it doesn't

I replaced the Ink Bird with a Bayite because as the weather has warmed the Ink Bird will only control withing a 2-degree swing. The Bayite has a .1 degree resolution.

Have any of you seen this happen with Neo-Therm? Is perhaps a 2-degree separation between the heater and controller not enough, or is the Neo-Therm just toast?

Below is some additional background info if it helps.

I have the Bayite set to 78 and the Neo-Therm set to 80. Them temp control point is set to .6 on both heat and cool a 1.2-degree total swing.
But the issue I'm having with Neo-Therm started before I put it on the Bayite (while it was still on the Ink Bird) and Bayite is working fine. I've tested the Bayite by plugging something into the heater plug when there is power to it and the Neo-Therm is not heating. In fact, as I mentioned when I unplug the Neo-Therm for a few seconds and then replug back the Bayite the Neo-Therm will start heating.

Any ideas?
 
I would ditch the neotherm asap, these things have destroyed many tanks :(. Ironically I have the smallest one they make in a 14 gallon biocube thats been running flawlessly for 5 years but I will never buy another.
 

IF YOU HAD TO TAKE A REEFING EXAM, WOULD YOU PASS?

  • Yes!

    Votes: 30 44.8%
  • Not yet, but I have one that I want to buy in mind!

    Votes: 9 13.4%
  • No.

    Votes: 25 37.3%
  • Other (please explain).

    Votes: 3 4.5%
Back
Top