Neptune Apex - New FMM module makes another module "disconnect"

[CasperOe]

Hi Reefers,

Here's a fun- and a strange one!

I recently replaced a FMM module as the old module was defective using the "Replace Module" task- and all is working fine.

I have managed to fix the broken FMM module and now, when I connect it to my Apex, the other one will show as "disconnected". It is worth noticing that the module that I connect does not show up.

I reckon the two modules have the same address maybe? Any way I can change this?

Cheers,

 

[braaap]

Hi Reefers,

Here's a fun- and a strange one!

I recently replaced a FMM module as the old module was defective using the "Replace Module" task- and all is working fine.

I have managed to fix the broken FMM module and now, when I connect it to my Apex, the other one will show as "disconnected". It is worth noticing that the module that I connect does not show up.

I reckon the two modules have the same address maybe? Any way I can change this?

Cheers,

Delete them both and start over. The module replace is just that. It expect you to completely replace it and is giving you the same address so you don’t need to do more programming. Start fresh and you shouldn’t have an issue.