Neptune Apex Tunze ATO shutoff return shutoff?

[RKeenan]

I'm sure this is a silly question but total newbie and still trying to figure things out. I know I saw it on here but cannot find it. Trying to figure out how to program it so when I switch the return pump off (Varios 6 thru outlet control) that it will switch off the outlet to the Tunze as well? Since it not relying on a module or switch do not see anywhere to add code.

 

[SuncrestReef]

You didn't say the names of your outputs, so just substitute your Various output name in this code added to the end of your ATO output programming:

If Output Varios6 = OFF Then OFF

See more tips in my series of Apex programming tutorials:

Articles by SuncrestReef

www.reef2reef.com

 

[RKeenan]

Thanks Suncrest. Actually followed you whole build and looked at a couple of the tutorials. Just confused.Output names are RETURN PUMP and TUNZE-ATO. Just not sure where the ATO output programming is.

 

[RKeenan]

So I think I got it. I have to switch the output to advanced instead of return pump or always on to open the configuration code box looks like.

 

[SuncrestReef]

So I think I got it. I have to switch the output to advanced instead of return pump or always on to open the configuration code box looks like.

Yes, I discussed this in my tutorial on Apex Control Types:

Apex Control Types

When I wrote my 8-part Apex Programming Tutorial series, all of the coding examples were applied to outputs where the Control Type was set to Advanced. Control Types are pre-set shortcuts to program an output for a specific device, allowing less...

www.reef2reef.com