Neptune ATK beeping ALOT

[If_Only]

So I didn't have a good experience with my ATO micro, so my LFS let me exchange it with a Neptune ATK (for only $50 extra so I technically got $15 off) but again, im not having a good experience with ANOTHER ato, both of which are some of the best regarded ATOs out there. The beep is a single beep but the pump isn't running the beeping just got off, even if the pump doesn't run for 5 minutes. Both sensors are underwater but thats because the ATK filled it up to that spot. The ATK is a standalone setup (for now) but the beeping is so annoying and if had better luck just doing manual top off over using this Neptune one.



Any thoughts are much appreciated (anyone with the ATK?) Thanks!

 

[hdsoftail1065]

Bump

 

[rkpetersen]

I have never used the standalone mode. However you should carefully go through the Standalone Mode info on these pages and see which might apply to your situation:

https://www.neptunesystems.com/getstarted/atk-help/

https://www.neptunesystems.com/getstarted/atk-help/ledalarmfaq/

Make sure that the two sensor connectors are both pushed firmly into their ports on the FMM.

Then power cycle the FMM to restart it, and make sure it restarts with the water level at or just slightly above the lower sensor.