Neptune cor 20 red

JustinMN18 · Jan 24, 2021

Hello,

I'm running the Neptune cor 20 by itself, and it's flashing red and not turning on. I have no idea why. it looks like it's the second dot that is flashing, so I tried another outlet on a different power strip, and nothing is changing. I have no idea what the deal is, and everything else on my tank is working perfectly. What should I do? It's so late at night and I have no other pump.

Tcook · Jan 24, 2021

Is this running off an apex?

JustinMN18 · Jan 24, 2021

No, it's stand alone, and it's flashing the second dot. Sometimes it turns on for a few seconds, then turns off, and flashes. Everything else is working. No idea what's happening.

Tcook · Jan 24, 2021

This was from another thread. Says second light is over voltage. Have you shut it down/unplugged it for 5-10 minutes and try a restart?

• An error condition exists. When the status LED is red, one of the LEDs of 8- LED bar will flash to indicate the specific issue detected. The COR driver has detected an overcurrent condition (LED #1, #4, or #5 may be flashing) This may indicate that the pump’s intake is blocked or a foreign object is preventing the impeller from rotating . The input power voltage is too high (LED #2 will be flashing) The input power voltage is low (LED #3 will be flashing) The COR pump is running while dry or out of water (LED #6 will be flashing) The internal temperature of the pump is high (LED #7 will be flashing)

JustinMN18 · Jan 24, 2021

Tcook said:
This was from another thread. Says second light is over voltage. Have you shut it down/unplugged it for 5-10 minutes and try a restart?

• An error condition exists. When the status LED is red, one of the LEDs of 8- LED bar will flash to indicate the specific issue detected. The COR driver has detected an overcurrent condition (LED #1, #4, or #5 may be flashing) This may indicate that the pump’s intake is blocked or a foreign object is preventing the impeller from rotating . The input power voltage is too high (LED #2 will be flashing) The input power voltage is low (LED #3 will be flashing) The COR pump is running while dry or out of water (LED #6 will be flashing) The internal temperature of the pump is high (LED #7 will be flashing)

Yea I have tried unplugging and everything and it turns on, starts pumping, and goes directly back to flashing read and turns the flow off. No idea what happened.