Neptune GRO light

[jisherwood]

Has anyone had to replace the 24 volt connector on the Refugium GRO light? Mine has some how trashed and I have no clue what happen to it. I have contacted Neptune support and am waiting on an email back on how much it is going to cost to repair. Looking for a good DIY idea. Thanks

 

[oreo54]

Has anyone had to replace the 24 volt connector on the Refugium GRO light? Mine has some how trashed and I have no clue what happen to it. I have contacted Neptune support and am waiting on an email back on how much it is going to cost to repair. Looking for a good DIY idea. Thanks

Looks like any 24v 1amp or greater power supply can run it.

Need a better look at what is " broke"?

 

[jisherwood]

Here you go finally had time to snap pic. Got a hold of Neptune tech support and their response not fixable Offered on at 50% off. Going to try with 24v 1amp power supply. If it doesn't work then purchase one @ 50%. Learned my lesson.

 

[oreo54]

Here you go finally had time to snap pic. Got a hold of Neptune tech support and their response not fixable Offered on at 50% off. Going to try with 24v 1amp power supply. If it doesn't work then purchase one @ 50%. Learned my lesson.

I believe this is the same plug
You could cannibalize this:
https://www.bulkreefsupply.com/dc24-10-extension-cable-neptune-systems.html

Am I missing something?
Oh if one could open the light easily you can replace the entire cord sans the one end you need to cut off.

 

[jisherwood]

Hey just cu the end off and marry up the broken piece. Solder the new end on and all is good to go. Thanks for the repair idea. Will update this once I get it replaced.

 

[jisherwood]

While snooping around Bulk Reef Supply found this cord:

DC24 to Bare Wire Accessory Cable

You can now use the 24vDC ports that are on the 1Link module and the EnergyBar 832. The 24v DC port will give you the ability to run solenoids, pumps, and fans off a single wire, without having to use any standard outlets for power. The 24v DC ports have give you full outlet style control in a...

www.bulkreefsupply.com

Just what the doctor ordered.

 

[oreo54]

While snooping around Bulk Reef Supply found this cord:

DC24 to Bare Wire Accessory Cable

You can now use the 24vDC ports that are on the 1Link module and the EnergyBar 832. The 24v DC port will give you the ability to run solenoids, pumps, and fans off a single wire, without having to use any standard outlets for power. The 24v DC ports have give you full outlet style control in a...

www.bulkreefsupply.com

Just what the doctor ordered.

Good find!

 

[Birdy64]

Here you go finally had time to snap pic. Got a hold of Neptune tech support and their response not fixable Offered on at 50% off. Going to try with 24v 1amp power supply. If it doesn't work then purchase one @ 50%. Learned my lesson.

I just purchased this same light last month. I went to rearrange my setup and the connector would not come out of my energy bar. I finally got it out and it is broke exactly the same as yours.

 

[jisherwood]

Instead purchased the following from Amazon. Cut the broken end off and reconnected the new ends. Works like a champ.

Molex Micro-Fit 3.0 dual row (2 Circuits) Male & Female receptacle plug, w/Terminal sockets, (Pack of 10 Complete Set)​

Brand: Molex

Red wire goes on top of connector and black next to the keeper side

Best od luck