Greybeard
2500 Club Member
Had a little ORA gonipora frag that was constantly being pushed around in the sand. A few minutes with OnShape, and I had a new thing to try...
Worked out great. Holds a 1/2" frag plug. Cover the base in sand, and it pretty much disappears. I used a light grey PETG, 100% infill, of course. So far, it's doing the job.
www.thingiverse.com
Worked out great. Holds a 1/2" frag plug. Cover the base in sand, and it pretty much disappears. I used a light grey PETG, 100% infill, of course. So far, it's doing the job.
Single coral frag stand by GreybeardFM
Intended to hold a single frag plug at sand bed level. Cover the edges, it pretty much disappears... no worries about your new frag being buried, falling over, or whatever. Overbuilt, it's quite stable. Set for 1/2" frag plugs. I designed for a little ORA red Gonipora frag that was constantly...
www.thingiverse.com
