Why the crawlspace, I wonder...It seems...dumb?
So I had theories, but most aren’t very good:
1) With the crawlspace, you get a full uninterrupted line of silicone across the bottom of the whole pane. Without the crawlspace, the two inside vertical dividers would go all the way down, and there would be less silicone at those intersecting points. Possible points of failure they were trying to avoid after the original nuvo curved glass fiascos.
However, the silicone in the bottom, could just snake around on both sides of those two panes, which I would assume would be enough, or they could make a little notch at the intersecting points to allow the full line of silicone on the back, plus the snaking around those two panes so…
2) Something in their manufacturing process makes it so it is not possible to go all the way down. Something like one part of the assembly line completed the whole outer tank, which then gets sent to another fabricator, which adds the overflow. Instead of cutting up the nice silicone at the edge, they just make the crawlspace.
3) It adds some sort of rigidity to the tank. I’m not quite sure how, since they put a glass pane directly behind the acrylic wall (which is very nice by the way and not all manufacturers do).
4) It allows more volume in the pump chamber. Not sure why this would matter, as the pump intake would go dry at essentially the same point.
5) It allows the media chambers on different height tanks to be roughly the same height, so you can interchange their media baskets, skimmers, and media reactors between similar volume tanks with varying heights. They have to manufacture a lot fewer parts, which reduces costs for them (and us). For example, the nuvoskim sits on rubber feet and is not attached to the tank. This is a decent reason, but i’m not sure it’s true as some tank measurements are missing from the manuals.
I’ve thought about this a lot lol, but couldn’t come up with a really good reason. I think only IM knows.