New to the hobby need help setting up m1 return pump

[Kimmi2413]

Hey guys so I have an m1 pump and been trying to set the controller to where I can control the flow manually and can’t figure out how to. I’ve done the calibration a bunch of times and just can’t get it to turn green to where I can control the flow myself. As on right now it’s on a dim green blinking setting with no lights on but the flow is still coming out enough to continue my tank cycle . Any answers would be nice, thanks in advance

 

[Crabs McJones]

Hey guys so I have an m1 pump and been trying to set the controller to where I can control the flow manually and can’t figure out how to. I’ve done the calibration a bunch of times and just can’t get it to turn green to where I can control the flow myself. As on right now it’s on a dim green blinking setting with no lights on but the flow is still coming out enough to continue my tank cycle . Any answers would be nice, thanks in advance

Have you tried a factory reset? I think blinking green means it's in battery backup mode

 

[Kimmi2413]

Have you tried a factory reset? I think blinking green means it's in battery backup mode

Yes I literally tried everything that I’ve found online and in the Manuel and still can’t get it right.

 

[Waters]

I am not sure if this is in the book or not, if it is, please ignore................this was emailed to me by ecotech.
With the controller powered on, press and hold the "mode" and "set" buttons until the dial blinks red, white, and blue.
Press and hold the "mode" button until the dial blinks red and purple.
Press and hold the "mode" and "power/option" buttons until the pump powers off and resets.

 

[Kimmi2413]

I am not sure if this is in the book or not, if it is, please ignore................this was emailed to me by ecotech.
With the controller powered on, press and hold the "mode" and "set" buttons until the dial blinks red, white, and blue.
Press and hold the "mode" button until the dial blinks red and purple.
Press and hold the "mode" and "power/option" buttons until the pump powers off and resets.

Just did that it goes to a green light now and can control the flow but there’s no flow coming out

 

[Kimmi2413]

Turns out the wrong cable was connected to it. It’s working good now thanks for the help tho guys!