Hi all, I would like to kill off GHA and am contemplating using Nopox. My understanding is that it will reduce no3 and po4 levels.
I do however worry about using it causing Cyanobacteria and dinos when po4 levels are depleted too fast.
I am thinking about buying but have not seen many positive reviews where algae actually disappears from a tank.
Also worried what it could do to my corals as I have loads of Ricordea Florida, lps and very few
Run AI prime with no red or green and white at 10%.
All tested this morning 12/04/2020
SG is low at 1.022 but brining it up slowly over the next week or so.
Alk 9.6dKh Target 9
Cal 415 ppm Target 420-450
Mg 1390 ppm (bit high) Target 1280-1350
No3 0-2 ppm
Po4 zero
all tested with salifert kits. As I have algae these no3 and po4 are not accurate.
or
I know it’s not the solution long term.

I do however worry about using it causing Cyanobacteria and dinos when po4 levels are depleted too fast.
I am thinking about buying but have not seen many positive reviews where algae actually disappears from a tank.
Also worried what it could do to my corals as I have loads of Ricordea Florida, lps and very few
Run AI prime with no red or green and white at 10%.
All tested this morning 12/04/2020
SG is low at 1.022 but brining it up slowly over the next week or so.
Alk 9.6dKh Target 9
Cal 415 ppm Target 420-450
Mg 1390 ppm (bit high) Target 1280-1350
No3 0-2 ppm
Po4 zero
all tested with salifert kits. As I have algae these no3 and po4 are not accurate.
or
I know it’s not the solution long term.


