NickHolmes
Active Member
Math isn’t a strong point so would appreciate some help. I’m dosing lanthanum and the recommended dosage reduces po4 by 1ppm and the tanks po4 is 0.16. Would that theoretically drop it to 0.06 or should I go back to school?
Numerically challenged, please help
- Thread starter NickHolmes
- Start date
- Tagged users None
Lavey29
10K Club member
Just half dose the recommended amount for your tank volume. .16 phosphate is not bad at all. You would probably find it easier to use a bag of phosguard which walks the phosphate number down slowly.
OP
OP
NickHolmes
Active Member
I’m not doing the recommended dosage, just asking if my understanding of the reduction with that dosage is correct
Lavey29
10K Club member
It depends on your tank volume
Last edited:
ReefingDreams
Active Member
You need to lay out tank volume and the instructions for the product/math that got you there. Otherwise we can't check your work.
1ppm should be equivalent to 1.0ppm if you're working in the same units. If so, you would overdose, drive your number to 0.0, and have excess/unbound LC in your water.
OP
OP
NickHolmes
Active Member
Sorry I should have said I already worked out the recommended dosage to reduce it by 1ppm for my tank is 20ml. I’m just asking if 1ppm reduction will theoretically reduce my po4 from 0.16 to 0.06.
ReefingDreams
Active Member
No. See my prior comment. 1PPM does not equal 0.1PPM.Sorry I should have said I already worked out the recommended dosage to reduce it by 1ppm for my tank is 20ml. I’m just asking if 1ppm reduction will theoretically reduce my po4 from 0.16 to 0.06.
Lavey29
10K Club member
Exactly 1ppm is 10x more then .1ppm
- Joined
- Sep 21, 2018
- Messages
- 7,571
- Reaction score
- 7,962
0.16 ppm - 1 ppm = - 0.84 ppm which is likely to be 0 ppm.Sorry I should have said I already worked out the recommended dosage to reduce it by 1ppm for my tank is 20ml. I’m just asking if 1ppm reduction will theoretically reduce my po4 from 0.16 to 0.06.
OP
OP
NickHolmes
Active Member
Hell this is embarrassing. Thank you, just as well I asked first
OP
OP
NickHolmes
Active Member
Randy Holmes-Farley
Reef Chemist
Staff member
Super Moderator
Excellence Award
Expert Contributor
Article Contributor
R2R Research
My Tank Thread
I'll give a contrary opinion: I don't think such calculations are useful except to prevent an initial overdose.
Specifically, if you calculated that lanthanum would drop phosphate from 1 ppm to 0.05 ppm, and then monitored the phosphate over the next few days (even with no feeding), it likely will not drop that low, and will rise a long way back toward the 1 ppm due to desorption from rock and sand.
Thus, I'd only use a calculation as a starting dose and then stop calculating and just go by trial and error based on testing.
Specifically, if you calculated that lanthanum would drop phosphate from 1 ppm to 0.05 ppm, and then monitored the phosphate over the next few days (even with no feeding), it likely will not drop that low, and will rise a long way back toward the 1 ppm due to desorption from rock and sand.
Thus, I'd only use a calculation as a starting dose and then stop calculating and just go by trial and error based on testing.
