Older MP10 control?

[GalaxyBenny]

Hey guys -

Does anyone know if a 2011 vintage MP10 can be controlled with the vortech controller? I see clearly where there are issues with the newest software versions, but I assume there is also a backward cut-off. Any advice would be most appreciated.

Cheers!

 

[GalaxyBenny]

@Vinny@GHLUSA - Any thoughts on this? I see from your website that any firmware version prior to 1.4.1 should work with the Vortech controller. So even though the pump is Ecotech MP10 is a 2011 model, it should work with the GHL controller right? Can a pump be TOO old or not have the right feature to physically connect with the GHL Vortech controller?

 

[TangerineSpeedo]

You can purchase an upgrade driver MP10QD for $50 from BRS and add a now available mobius chip if that helps. I ave upgraded 3 MP10's with white drivers. I get them off the webs for under $100
Hope this helps, not familiar with the GHL workings but you can bring your MP10 into current specs for under $100

 

[Vinny@GHLUSA Verified Sponsor]

Any Vortech pump that is running pre-mobius firmware, will work with the GHL Vortech Controller accessory.

How to setup Vortech pump control - GHL Advanced Technology

www.aquariumcomputer.com

Mobius FW has locked out 3rd party control and FW rollback is not an option.

 

[TangerineSpeedo]

I have a couple of White controllers with green boards if you need them...

 

[GalaxyBenny]

Thanks so much. I will let you know. I assume your green board models have the wifi module? From all my reading and the responses above, it seems like the Mobius capability (black board) doesn't matter in my case. I just need it to have the wifi so that it can communicate with the GHL Vortech control module.

Full disclosure, I'm actually looking to purchase these MP10s from another local hobbyist, so I just wanted to make sure the older version would work before I pulled the trigger. I think I now have enough info to go check out the units and determine if they have the right board/serial number/illuminated "W" to confirm if they will work for me.

Again it's much appreciated though. I will let you know.

 

[TangerineSpeedo]

Don't pay more than $100 for a complete unit. I have revamped a few MP10's so that is about the current value

 

[GalaxyBenny]

The guy is offering 2x MP10s for $100. So it seemed like a good deal, especially if they are Wi-Fi and will connect with the GHL.

I like my Nero 3 well enough, but annoyed at not being able to control feed mode etc from one place. Hoping to try everything in one app instead of 2. Depending on what I find when I see the pumps I’ll let you know on the controllers. Thanks again.