ReefPiracy
Active Member
I was wondering what everyone or is ideal for the heat sink temperature sensor in the device status, running 38 C @ 100% output.
Replaced my board and noticed a few things. The white grease was applied all over the heat sink but only was on a few spots on the led board. Any time I do a PC build you just do a rice blob and let the pressure apply the paste. Also 3 out of 4 screws holding the control board, past flush and would have kept the led board off the heat sink by a mm or two.
Replaced my board and noticed a few things. The white grease was applied all over the heat sink but only was on a few spots on the led board. Any time I do a PC build you just do a rice blob and let the pressure apply the paste. Also 3 out of 4 screws holding the control board, past flush and would have kept the led board off the heat sink by a mm or two.
