BillyKVT
Community Member
Hello all! I am expecting my clear-for-life 60G to arrive this upcoming week and I am trying to finalize my overflow design before I start cutting on the waterjet.
Since the tank is acrylic, I was thinking of just fusing the overflow box to it using Weldon 4 acrylic. This is my first serious build and I haven't had any experience with overflows before. My question is if I'll ever need to remove it for cleaning purposes.
Assuming I've made the permanent bond and something happens down the road where I need to get in there, how would I go about removing the box?
Thanks in advance.
Since the tank is acrylic, I was thinking of just fusing the overflow box to it using Weldon 4 acrylic. This is my first serious build and I haven't had any experience with overflows before. My question is if I'll ever need to remove it for cleaning purposes.
Assuming I've made the permanent bond and something happens down the road where I need to get in there, how would I go about removing the box?
Thanks in advance.
I figured it was more applicable in the DIY section. Thanks
