P4 Powerbar 5.1 Socket S5 stopped working

[Jeremy Luke]

So I redid my socket assignments on my two Powerbars so that I could directly control my ATO pump as I received my level sensor from GHL today. I removed my return pump from the S5 socket and plugged in my two 300w heaters (connected via a cord) to the S5 socket. The socket will not turn on now. Even if I set it to "always on" The two heaters were previously plugged into the same powerbar on sockets S1 and S2. I tried powering off the powerbar (with the switch) and restarting the controller. This unit is only a few months old. Did it really break somehow? Is there some other way I can try to "reset" the powerbar?

 

[Jeremy Luke]

Got it. Please discard. I guess reading a manual every now and then might be a good idea. So I guess I'll be needing a fuse

 

[olson2886]

Hi which type of fuse did you need and did it work? Same issue!

 

[Lasse]

Here you find the fuse

Its a standard 2 A glass fuse . when I replace one back in the days - I use a slow-blow standard 2 A fuse like this one- If I remember right - it was a 5x20 mm fuse. But take out yours and measure - I use standard Europe version - it can be different with the US version

Sincerely Lasse