PH is High

Probably an error imo. I wouldn't worry unless you are adding high pH additives
 
What are you using to test it
 
FWIW, pH is NEVER too high (IMO, pH > 8.55) in a normally aerated reef than that is not using very high pH alkalinity additives and does not have excessively high alkalinity (IMO, > 11 dKH). :)
 
FWIW, pH is NEVER too high (IMO, pH > 8.55) in a normally aerated reef than that is not using very high pH alkalinity additives and does not have excessively high alkalinity (IMO, > 11 dKH). :)
Randy, My tank previously ran consistently at PH 8.1. I recently added a CO2 scrubber and now my PH is testing 8.6 using Hanna checker. My dKH is 8.5. Its been 3 days since I installed the scrubber and I see no negative change in my tank. I'm monitoring to see if I can see an increase in alkalinity and calcium usage. I use Seachem Reef Buffer to adjust new H2O and I dose 2 Little Fishes 2 Part Supplement. You see no issue with PH 8.6?
 
Randy, My tank previously ran consistently at PH 8.1. I recently added a CO2 scrubber and now my PH is testing 8.6 using Hanna checker. My dKH is 8.5. Its been 3 days since I installed the scrubber and I see no negative change in my tank. I'm monitoring to see if I can see an increase in alkalinity and calcium usage. I use Seachem Reef Buffer to adjust new H2O and I dose 2 Little Fishes 2 Part Supplement. You see no issue with PH 8.6?
You are approaching the pH where precipitation could increase, a lot. Not sure how you will tell the difference between coral growth and abiotic precipitation, except visually noticing build up on heaters and pumps etc.
 
You are approaching the pH where precipitation could increase, a lot. Not sure how you will tell the difference between coral growth and abiotic precipitation, except visually noticing build up on heaters and pumps etc.
Thanks, that's what I've been able to determine as well. Now the question is do I take off the CO2 scrubber or possibly run the skimmer without the scrubber part time. Hmmm. Think I'll pay attention to dKH, Calcium and PH the next few days and keep my fingers crossed
 
Thanks, that's what I've been able to determine as well. Now the question is do I take off the CO2 scrubber or possibly run the skimmer without the scrubber part time. Hmmm. Think I'll pay attention to dKH, Calcium and PH the next few days and keep my fingers crossed
Would certainly save some of that expensive media if you could bypass it either part time, or partially, if you decide you don’t need to run at 8.5 or 8.6. Something cheap, like a “t” fitting with a valve on it that could be set to bring in untreated air perhaps.
 

IF YOU HAD TO TAKE A REEFING EXAM, WOULD YOU PASS?

  • Yes!

    Votes: 32 45.7%
  • Not yet, but I have one that I want to buy in mind!

    Votes: 9 12.9%
  • No.

    Votes: 26 37.1%
  • Other (please explain).

    Votes: 3 4.3%
Back
Top