MonsterReef
Well-Known Member
How do you bring ph up
My dkh 9.2
Mag 1400
Cal 380 to 400
Am I ok at these levels
My dkh 9.2
Mag 1400
Cal 380 to 400
Am I ok at these levels
Ph
- Thread starter MonsterReef
- Start date
- Tagged users None
jsker
Reefing is all about the adventure
One of there ways, test need to be replace, fresh air to the skimmer, or baking soda that has been bake at 300 for 1.5 hrs. the baking soda method will raise your alk though.
OP
OP
MonsterReef
Well-Known Member
Ph 7.4
OP
OP
MonsterReef
Well-Known Member
So add a air stone for a while
happyhourhero
Burner of the Tips
I would not chase PH.
OP
OP
MonsterReef
Well-Known Member
Ok
OP
OP
MonsterReef
Well-Known Member
Also I have a new tank that has been cycling for a week
OP
OP
MonsterReef
Well-Known Member
Dkh is 14.00 what do I do for it
I would not even address the pH until the tank is fully cycled, the pH is going swing until the cycle is complete. If you have not added any live stock just sit back and let the system cycle. You're wasting testing supplies and supplement products if you attempt to correct the values now.
First post a dkh of 9.2, in post#9 a dkh of 14.00?
If after the tank has completely cycled you're still seeing a pH lower then 7.8 chronically then consider one the many methods of maintaining a higher pH value.
One of my favorite links below.
http://reefkeeping.com/issues/2004-05/rhf/
Remember pH values raise and fall in a 24 hr periods, with the lowest values present when the lights have been off.
What did you use to cycle the tank?
First post a dkh of 9.2, in post#9 a dkh of 14.00?
If after the tank has completely cycled you're still seeing a pH lower then 7.8 chronically then consider one the many methods of maintaining a higher pH value.
One of my favorite links below.
http://reefkeeping.com/issues/2004-05/rhf/
Remember pH values raise and fall in a 24 hr periods, with the lowest values present when the lights have been off.
What did you use to cycle the tank?
OP
OP
MonsterReef
Well-Known Member
The dkh of 9.2 is in my established tank the dkh of 14.00 is in the new tank
OP
OP
MonsterReef
Well-Known Member
nervousmonkey
LPS Lover, SPS Enabler
don't worry about pH in a cycling tank, the byproducts of cycling it will drive your pH down, but who cares what that ph is since you have nothing in it yet. If your pH is 7.4 in your established tank, then I would worry about it. Not the pH value per se, but what in the world is causing it to get that low. Don't chase pH but look at it as a tool to make sure that you are playing in the right ballpark.
Is the pH that low in the cycling tank or the established tank?
Is the pH that low in the cycling tank or the established tank?
Randy Holmes-Farley
Reef Chemist
Staff member
Super Moderator
Excellence Award
Expert Contributor
Article Contributor
R2R Research
My Tank Thread
If the pH really was 7.4, that would be a serious issue, but it isn't likely to be accurate.
OP
OP
MonsterReef
Well-Known Member
Starting not to trust api test kit
Your best bet of getting close to true numbers with hobby grade kits is to have multiple of them and take multiple readings.
As far as the air mentioned earlier, you don't just need an air stone you need fresh air from outside injected to your tank to remove excess CO2 and raise the pH. A lot of people though run an airline outside their house and put at their skimmers intake. Another solution is a refugium with macro algae with a reverse light cycle from the dt or a 24/7. But what i would try as an easy test would be to open a door or a window in the room the tank is in for an hour or two and test pH afterwards. That will probably make a difference. Do you have any means of promoting gas exchange (power head pointed at the surface, sumo/overflow, skimmer, flow etc)?
So to summarise, if i were you, I'd get a salifert test kit, take pH reading with both kits before and after opening the door and take it from there...
PS: here's an article from none other than Randy http://www.reefkeeping.com/issues/2004-09/rhf/
As far as the air mentioned earlier, you don't just need an air stone you need fresh air from outside injected to your tank to remove excess CO2 and raise the pH. A lot of people though run an airline outside their house and put at their skimmers intake. Another solution is a refugium with macro algae with a reverse light cycle from the dt or a 24/7. But what i would try as an easy test would be to open a door or a window in the room the tank is in for an hour or two and test pH afterwards. That will probably make a difference. Do you have any means of promoting gas exchange (power head pointed at the surface, sumo/overflow, skimmer, flow etc)?
So to summarise, if i were you, I'd get a salifert test kit, take pH reading with both kits before and after opening the door and take it from there...
PS: here's an article from none other than Randy http://www.reefkeeping.com/issues/2004-09/rhf/
FishOfHex
Reefer & 3D Printer
Hope this helps
