My piranha magnet is only scrubbing using one side of a tiny corner of the blade... No matter how much I tighten or how I tighten it or position, the entire blade never comes into contact with the glass to scrape off algae.
Blade looks even/ flush...when viewed from front though...
This happens even with new blades.
Is it because there's a gap between the blade holder and back of magnet?
Looking at pic shall I put glue and compress the holder to magnet where there is gap where light is visible?
I'm guessing this will prevent the holder to Bend back when it hits the resistance in the glass..?
Thx
Blade looks even/ flush...when viewed from front though...
This happens even with new blades.
Is it because there's a gap between the blade holder and back of magnet?
Looking at pic shall I put glue and compress the holder to magnet where there is gap where light is visible?
I'm guessing this will prevent the holder to Bend back when it hits the resistance in the glass..?
Thx
