Port on Gyre 250 Controller Not Working

AngryOwl · Jan 12, 2019

Hey guys,

Just noticed today that port A is not working on my gyre 250 controller. I use two pumps on the controller and port B is working fine. I confirmed this is NOT a pump issue because each pump works fine when connected to port B.

I also did a power cycle with no luck.

Has this happened to anyone else? Any luck fixing it?

I put in a support ticket with coralvue but want to see if y'all have any experiences with this.

User1 · Jan 12, 2019

I've not seen this. I was going to suggest you swap them around but you already did that

Only other thing I can suggest is check the pins, that it is seated all the way in, firmly, and that it is correctly positioned. I'm sure you already did this but doesn't hurt to ask.

I was also going to suggest that you check thepump itself that everything is seated properly (blades, cages, etc). But I think you said it was working fine with on the other port.

User1 · Jan 12, 2019

One other thing - and I'm sure you already checked - but is that port set to run? One time I plugged one in channel B and didn't see it move. Then I looked at the controller and it was set to the straight arrow -> and 0.

AngryOwl · Jan 12, 2019

saf1 said:
One other thing - and I'm sure you already checked - but is that port set to run? One time I plugged one in channel B and didn't see it move. Then I looked at the controller and it was set to the straight arrow -> and 0.

haha yes! Both ports set to constant speed of 50%.