Powerhead Mesh Size

[Reefing102]

I’m looking to build my own mesh covers for my power heads. What size mesh should I be looking for to cover my power heads for anemones? 1/4 inch or something smaller?

I tried a quick search but mostly found mesh top info

 

[Fish Think Pink]

I’m looking to build my own mesh covers for my power heads. What size mesh should I be looking for to cover my power heads for anemones? 1/4 inch or something smaller?

I tried a quick search but mostly found mesh top info

Did you look at NemProtect ? they are a commercially available 3D plastic printed product that is both side and top/front mesh - estimate its holes are a bit smaller than about 1/4" each but I'm eyeballing not measuring... copyrighted by Wavemaker Protector Guards/Paul Burns 2018. Good luck to you!

 

[Lost in the Sauce]

This product worked great.

 

[Reefing102]

Did you look at NemProtect ? they are a commercially available 3D plastic printed product that is both side and top/front mesh - estimate its holes are a bit smaller than about 1/4" each but I'm eyeballing not measuring... copyrighted by Wavemaker Protector Guards/Paul Burns 2018. Good luck to you!

Honestly never heard of them lol I’ll look into them.

I’ll also look at that mesh sheet

 

[Fish Think Pink]

Honestly never heard of them lol I’ll look into them.

I’ll also look at that mesh sheet

If I'd have seen that plastic mesh sheet, I probably would have DIY'd something. I mentioned NemProtect more to look at hole size. I like mine and they work good, but usually I am on budget so I'll try something cheap DIY and if it fails then spend $$ (because sometimes I can save $$ or $$$ <giggle>)