ProfiLux 4 – What will I need?

[Lasse]

Touch display can be connected to any open PAB port. You can plug it off of the P4, powerbar, dosing pump, etc.

Powerbars need to be connected off of a P4, expansion box, or existing powerbar.

Reading between the lines - will this indicate that I can´t have a PAB line like this P4-Tuch-PB-PB-Doser2-Doser2-Doser2- EXPbox-PB? It works for the P3 but I have had a lot of problems with P4 and this configuration. Top of line firmware on both.

Sincerely Lasse

 

[Support@GHLUSA Verified Sponsor]

Reading between the lines - will this indicate that I can´t have a PAB line like this P4-Tuch-PB-PB-Doser2-Doser2-Doser2- EXPbox-PB? It works for the P3 but I have had a lot of problems with P4 and this configuration. Top of line firmware on both.

Sincerely Lasse

For most reliable results, regardless of P3 or P4, we always recommend having the PB's either on their own line, or direct connected vs a bunch of other devices between.

 

[Lasse]

@Marco@GHLUSA Thank you for answer.

Another question - Can the PAB bus hardware be damage if you connect and/or disconnect the RJ 45 contact with the power on?

Sincerely Lasse

 

[Support@GHLUSA Verified Sponsor]

Not to my knowledge, as long as it it a PAB connection.
Plugging LAN RJ45 into the PAB connection can though.

 

[Lasse]

Do I understand you right "A straight pair twinned cable with RJ 45 contact" can be connected as long as the other end is not in a LAN network ?

I have been out for some strange things with P4, 3PB 5.1, 3Doser 2 S, 1 exp box and a tuch. My p4 does not recognize any PAB connection - but my P3 does it.

Sincerely Lasse