Programming Quesiton Regarding ATO

[WillH]

Fallback OFF
Set OFF
If RES_Lo OPEN Then OFF
If ATK_Lo OPEN Then ON
If ATK_Hi CLOSED Then OFF
When On > 030:00 Then OFF
Defer 001:00 Then ON
Defer 000:04 Then OFF
Min Time 030:00 Then OFF


Is this programming not shutting off ATO when RES_Lo (switch in my reservoir because it is too high up in the code? "If RES_Lo OPEN Then OFF"

 

[Ronald Brown]

This is how I set mine.

 

[WillH]

I appreciate that. Mine works fine normally as well. Only having problems when adding the low resivior sensor

 

[WillH]

I read the APEX programming guide and found that the last if will override anything above it, so the correct code here is:

Fallback OFF
Set OFF
If ATK_Lo OPEN Then ON
If ATK_Hi CLOSED Then OFF
If RES_Lo OPEN Then OFF
When On > 030:00 Then OFF
Defer 001:00 Then ON
Defer 000:04 Then OFF
Min Time 030:00 Then OFF