Pump Groups - Maintenance

[KStatefan]

I have three pumps in a pump group. I created a maintenance function in that i programmed the 1-10 v interfaces for those pumps to 100%. When I turn on that maintenance function I do not see the the power for the pump change in the pump group dashboard. Does the maintenance function override the pump group settings and not show up on the dash board. If it maters these a Tunze powerheads.

 

[Lasse]

I have did it in another way - i have create a function the pumpgroup that answer to a maintenance function

I have a Tunze pump that I have assigned to my pump group 3. When maintenance 1 is activated - it should follow a activity program - in my case going down to a steady 15 %. You can do the same in your case but set it to 100 % and every time you activate your maintenance x program - they will run at 100%. Show in GCC because its easier to understand

It works for my Versia too

Sincerely Lasse

 

[KStatefan]

I have did it in another way - i have create a function the pumpgroup that answer to a maintenance function

I have a Tunze pump that I have assigned to my pump group 3. When maintenance 1 is activated - it should follow a activity program - in my case going down to a steady 15 %. You can do the same in your case but set it to 100 % and every time you activate your maintenance x program - they will run at 100%. Show in GCC because its easier to understand



Sincerely Lasse

Thanks I will try that.

 

[KStatefan]

That worked for me thanks