Quick question on drill bit sizing

[JB33t]

For 3/4 inch pipe/ bulkhead I use a 20mm diamond drill bit and for 1” pipe I use a 25mm? Is this correct just want to make sure before I start drilling. Thank you

 

[JoshH]

For 3/4 inch pipe/ bulkhead I use a 20mm diamond drill bit and for 1” pipe I use a 25mm? Is this correct just want to make sure before I start drilling. Thank you

Not correct... give me one minute and I'll throw a link in with the appropriate sizes

 

[JB33t]

Not correct... give me one minute and I'll throw a link in with the appropriate sizes

Thank you!

 

[JoshH]

Thank you!

So if these are Schedule 40 bulkheads, looking at the information above you need a 35mm drill bit for a 3/4" bulkhead and 45mm for a 1" bulkhead. Schedule 80 will be bigger

 

[JB33t]

So if these are Schedule 40 bulkheads, looking at the information above you need a 35mm drill bit for a 3/4" bulkhead and 45mm for a 1" bulkhead. Schedule 80 will be bigger

Thank you so much! Thankfully You answered that question before drilling.

 

[JoshH]

Thank you so much! Thankfully You answered that question before drilling.

No problem! Do you have the bulkheads on hand yet?

 

[JB33t]

No problem! Do you have the bulkheads on hand yet?

I do not

 

[JoshH]

I do not

But you are using Schedule 40 bulkheads correct? Just double checking

 

[JB33t]

But you are using Schedule 40 bulkheads correct? Just double checking

Yes I’m going to order those bulk heads from the BRS website where you found that chart. Thank you for your help

 

[JoshH]

Yes I’m going to order those bulk heads from the BRS website where you found that chart. Thank you for your help

Perfect!!! Best of luck on your new build!!