Radion XR15 Ceiling Mount Sag

[mjszos]

Hi all,

I recently installed an XR15 G6 Pro using their ceiling mount hardware, however I’m incredibly unhappy with the sag from the power cable extruding from the back. It’s tilting the light backwards and turning it about 15 degrees. It’s a real eye sore - wondering if anyone has any suggestions?

I’ve been tweaking with the balancing of the mounts to try and address the issue which is why you’ll see it’s angled towards the front of the tank now - but I can’t seem to get the cord right.

Also curious how people handle this with the RMS for multiple lights. Since you can daisychain them with master/slave lights it seems like a very unattractive mounting system unless I’m overlooking something. Possibly route the cables against the wall directly back with wall channels?

 

[Hydrored]

Hi all,

I recently installed an XR15 G6 Pro using their ceiling mount hardware, however I’m incredibly unhappy with the sag from the power cable extruding from the back. It’s tilting the light backwards and turning it about 15 degrees. It’s a real eye sore - wondering if anyone has any suggestions?

I’ve been tweaking with the balancing of the mounts to try and address the issue which is why you’ll see it’s angled towards the front of the tank now - but I can’t seem to get the cord right.

Also curious how people handle this with the RMS for multiple lights. Since you can daisychain them with master/slave lights it seems like a very unattractive mounting system unless I’m overlooking something. Possibly route the cables against the wall directly back with wall channels?

Zip tie the power cord so it’s supported off one of the two main hanging wire and place a channel like you described

 

[mjszos]

Zip tie the power cord so it’s supported off one of the two main hanging wire and place a channel like you described

This is brilliantly simple. I will give it a shot.

 

[mfinn]

I use a cable wall mount on mine.