Radion xr15 RMS Slide

[naysel]

Hello

Does anyone have Ecotech xr15 RMC Slide file to print?

I trie to do but i'm a noob so if some one can help i aprreciate.

Thanks

 

[blaxsun]

I would not trust a 3D-printed slide to hold up my Radion. Just my $0.02.

 

[theatrus]

I would not trust a 3D-printed slide to hold up my Radion. Just my $0.02.

Honestly, printed the right way and from the right material, it’s fine.

And for the OP, time to do some modeling. The hole pattern is square and the slide mount is just 25mm extrusion. The Radions are designed in metric.

That said, the RMS arms aren’t expensive. A few prototypes later and your filament spool might be the cost of one mount, plus you need to buy the screws.

 

[cilyjr]

That said, the RMS arms aren’t expensive. A few prototypes later and your filament spool might be the cost of one mount, plus you need to buy the screws.

You ain't lying!