Red Sea reefer cabinet doors

[Han]

I have two reefer 350s and on both of them one door always sits out a tiny bit further than the other. It’s barely even noticeable but I’m a little ocd about this stuff so it kind of bothers me. On the cabinet pictured the right door sits flush against the stopper but on the left door it’s not quite flush. Anyone else have this problem or any solutions? Maybe I should I just stop letting something so minor bother me...

 

[UCF Alum]

The hinges on the inside are adjustable. You’ll need to make 1/4 turns at a time to get them lined up properly

 

[Han]

The hinges on the inside are adjustable. You’ll need to make 1/4 turns at a time to get them lined up properly

I tried that, but it only moved the doors up or down.

 

[UCF Alum]

Do you have these hinges?

 

[Han]

Do you have these hinges?

Yes, I tried adjusting this screw.

 

[Han]

 

[UCF Alum]

Adjust the back screw that “kicks” the door in and out. Then you’ll have to fine tune with the front screws. If this doesn’t work, it’s possible that your doors are slightly warped. I’ve seen threads with people talking about that.
Your hinges are a little bit different than mine. The arm on my hinge comes out a little bit more than yours does.

 

[Han]

Adjust the back screw that “kicks” the door in and out. Then you’ll have to fine tune with the front screws. If this doesn’t work, it’s possible that your doors are slightly warped. I’ve seen threads with people talking about that.

I tried that, it made it better than it was but it’s still off slightly. Probably just the door, it’s just odd that both my tanks seem to have the same issue.