Red Sea Reefer P650 Cabinet Door Hinges

[psumms]

Anyone know the part number for replacement cabinet door hinges on a Red Sea Reefer Peninsula 650? Mine are pretty well rusted up and i'm having problems getting getting the info from Red Sea! Ideally looking for original Red Sea replacements - unless there is a know (Reliable) compatible manufacturer?

 

[dmy535]

Fish tanks direct has all the parts for the Red Sea cabinets. You can buy a cabinet kit from them. Sorry I do not know the part number though

 

[mikedoes]

Fish tanks direct has all the parts for the Red Sea cabinets. You can buy a cabinet kit from them. Sorry I do not know the part number though

I thought they are SS.

 

[dmy535]

I thought they are SS.

They are. Not sure what happened here?

 

[psumms]

The pins aren't rust-proof. Red Sea suggested using silicon grease to protect them.

 

[dmy535]

The pins aren't rust-proof. Red Sea suggested using silicon grease to protect them.

Did you find the hardware?

 

[psumms]

No, just covered them in vaseline.

 

[JDowns]

If you look on the backside of the cup there should be a stamped number. Most likely "304".

If you google search for a 304 stainless steel cabinet hinge you should be able to find your match. These hinges are widely copied and can vary. You need to measure the cup, the part of the hinge that recesses into the door or the hole in the door itself. Most likely your cup is 35mm diameter with a 13mm depth. I haven't seen how the doors work on your model but I'm assuming a 110 degree opening with a full overlay. I would bet a Blum Cliptop 110 with a full overlay would work for your situation. Otherwise just google "cabinet door hinge 304" and pay attention to the cup diameter / depth, angle of opening, and overlay.

 

[JDowns]

If you look on the backside of the cup there should be a stamped number. Most likely "304".

If you google search for a 304 stainless steel cabinet hinge you should be able to find your match. These hinges are widely copied and can vary. You need to measure the cup, the part of the hinge that recesses into the door or the hole in the door itself. Most likely your cup is 35mm diameter with a 13mm depth. I haven't seen how the doors work on your model but I'm assuming a 110 degree opening with a full overlay. I would bet a Blum Cliptop 110 with a full overlay would work for your situation. Otherwise just google "cabinet door hinge 304" and pay attention to the cup diameter / depth, angle of opening, and overlay.

Pay attention to the overlay! If the door is an end door that overlays the cabinet edge fully then a full overlay. If the door is in the center and shares an overlay with another door on a cabinet edge it may be a half overlay.

 

[psumms]

Thanks @JDowns very helpful info. I've searched previously for a close match based on the cup dimensions but never been able to find a hinge with the four holes in the plate:

 

[JDowns]

Thanks @JDowns very helpful info. I've searched previously for a close match based on the cup dimensions but never been able to find a hinge with the four holes in the plate:

Not sure, but judging by the picture that looks like an inset hinge, the door sits inside the frame, so no overlay.

Something like these:



This last one appears to be a close match. You would have to check dimensions.

 

[BigTex]

Were you ever able to find a match? Mine have rusted out on one side.