My apex flowmeter gave it away..
I have the nozzles near the surface of the water and can watch the surface of the water go still then it becomes turbulent then still and so on. I don’t have a type of flow meter. So basically I am SOL as far as getting a replacement. Thank you for the reply.I am running two Varios8 pumps with no issues. I did have one replaced though as it had a similar issue. It would spike up and then drop down again inconsistently.
What do you use to measure the pressure? How do you know its happening?
I contacted the UK distributor and had mine replaced, although it was within warranty at the time.
I’ll reach out to them, and I do need a pump for my make shift mixing station. So I’ll probably use until I find a replacement. Then use this pump for mixing saltwater. At least there is no live stock in tank yet.If it comes on just fine again with no immediate interruption id just keep it and not replace it! You may want start setting aside some funds for when it does break though, but chances are it will run just fine
Maybe contact CoralVue for advice, it may be that you can reset it somehow or have a new driver at a reduced cost.
