ReefandBeeR Custom Build 450g

[ReefAndBeer]

Update:
I replaced all my rocks with DD dry rocks. I think it has a simpler look, there was space to put a lot of coral. After the rock change, I entered 50ml bacteria culture and 50ml bacteria food, I continue by entering 30-40ml bacteria food daily. The formation of diatoms on the rocks began and ends. Meanwhile, the siporax reactor continues to run, but I haven't done any tests yet. Also, I installed a 580 liter frag tank and I will start operating it soon.

 

[ReefAndBeer]

Greetings,
I haven't been using Nyos for a while due to the air hose that hardens and breaks due to ozone. I have been replenishing the hoses and running them for 1 week, but the accumulation of sediment at the bottom in the previous period has started to happen again. It is as if the bubbles cannot take the sediment up to the collection container. When I open and look at the collecting container, there are no large bubbles, there are always small bubbles, so I make the collection 3-4cm down from the overflow point, which seems to be inefficient. I opened the air inlets completely but there was no change in the situation. If anyone has an idea, I can listen and practice, or I will change the PS. I used the Reef Octopus Elite 220, which was a backup when I was not using Nyos, and it performed very, very well. Maybe if I can't solve the situation, I'll get another Elite 220.

I also tested on the weekend, the values came out like this:
Ca 430
No3 15-25
Po4 0.1-0.25
Kh 10.9
Mg 1500-1600
Potassium 380

I think that the height of Kh and Mg is due to Ca Reactor, I increased PH a little more and I will observe the situation to reduce melting.