dputt88
Active Member
so I run a 75 gal wide for my sump and there is a center brace right over the refugium chamber. Since there are several baffles siliconed into the sump can i cut away this center brace?
Remove Center Brace for Sump
- Thread starter dputt88
- Start date
- Tagged users None
Flippers4pups
Fins up since 1993
Can you post a picture?
ZoWhat
10K Club member
Center braces keep the water pressure from bowing the side glass out....like a wall collapsing outward
If you cut the center brace out....I'd find two spots where you are free to use straps that can be tightened to support the side glass.
Wrap these straps completely around the tank vertically and hand tighten them as hard as you can
I'm talking straps like these:
If you cut the center brace out....I'd find two spots where you are free to use straps that can be tightened to support the side glass.
Wrap these straps completely around the tank vertically and hand tighten them as hard as you can
I'm talking straps like these:
Last edited:
I would angle the light for the refugium. I cut a brace on a 55 gallon with thick glass and even though the sump was only filled up halfway after a year there was noticable bowing that made me nervous. It wasn't a typical 55 gallon from Petco with thin glass either.
Ron Reefman
Lets Go Snorkeling!
Reef Squad
Excellence Award
Reef Tank 365
Article Contributor
Tampa Bay Reef Keepers
MAC of SW Florida
Given the 5 baffles that have been added, and assuming they are very secure, I wouldn't worry about the center brace.
If you still have concerns, make 2 removable braces shaped like this. l__________l (this is obviously upside down from the way you would put them on the tank) Make them from plastic, pvc, wood, glass even just use clamps from HD or Lowes. Put one over each of the two baffle locations. Just make sure they fit down snug over the tanks plastic frame.
If you still have concerns, make 2 removable braces shaped like this. l__________l (this is obviously upside down from the way you would put them on the tank) Make them from plastic, pvc, wood, glass even just use clamps from HD or Lowes. Put one over each of the two baffle locations. Just make sure they fit down snug over the tanks plastic frame.
ca1ore
10K Club member
Excellence Award
Reef Tank 365
CTARS Member
Article Contributor
R2R TV Featured
I think that as long as the baffles are structurally sound, the center brace can be removed without major worry. I did something like this years ago, but because I am paranoid, I did silicone on a pair of eurobraces.
The baffles are going to help replace the center brace, but I would add something like a euro along the front and back panels to try and keep them from bowing out. Alternatively, you could replace the brace you are cutting out with two braces front/back at the top, at about equal thirds. They would be out of your way, but still give you some additional support in addition to the baffles.
