In hind sight I should have done the same, I decided to put in UV and a two outlet manifold. I might be wishing I got the M1. Let me know how it goes!
In hind sight I should have done the same, I decided to put in UV and a two outlet manifold. I might be wishing I got the M1. Let me know how it goes!
Hey, hows the fitment of the Klir in the fiji 20? Im considering it for mine!I’m still building mine out, but I fit a Vectra s2 in my Fiji cube 20. It’s a decently tight fit
It fits really well, I'm in the finished stages of my cabinet build and squeezes in nicely. I did have to get the secondary filter sock cover.
Nice, im glad i found this thread. I wasnt able to find any other people using a klir. I figured it fit based on measurements but i wasnt aure if i was going to need to make a custom piece of acrylic or something to swap into the sump chamber. I also see you cut the lid! Nice job... where you able to pick up orings to secure your heater? I just ordered some off amazon i hope will work.It fits really well, I'm in the finished stages of my cabinet build and squeezes in nicely. I did have to get the secondary filter sock cover.
So once I got the S2 flowing it's not putting enough flow out, could you snap a pic of how you got the M1 in the return section of your fiji 20? Thanks!
Hey, i picked up a klir for my fiji sump! Question for you. I found the sock hole cut out was a tad too small for all three of the included plates. It fits nicely without one installed. Is that how you have yours?It fits really well, I'm in the finished stages of my cabinet build and squeezes in nicely. I did have to get the secondary filter sock cover.
That's exactly what I did no plate sealed well without it. The klir cover work marginal at best though. Has to be perfectly over the hole for it to seal. I think I'll take a piece of square acrylic and cover the second hole.
Nice. I was actually thinking about getting a piece of acrylic and cutting out that rectangle in it and putting the screw hole as well. That way you could literally attach the klir to the acrylic plate like its one of the circle plates that came with it. Kind of like combining these parts into one:That's exactly what I did no plate sealed well without it. The klir cover work marginal at best though. Has to be perfectly over the hole for it to seal. I think I'll take a piece of square acrylic and cover the second hole.
Sorry just now got around to getting a pic. Ive been busy!
Ha! I took your word for it and installed the M2 last night. No problems with the fitment, loving the increase in flow.
Lol good deal! I hate to see the day i have to take it out for cleaning . It will not be fun!
