RODI Configuration

[Echomsp]

I'm using a system with 2 RO membranes. I'm questioning the configuration of the lines into and out of the RO membranes.

Out of the box, the source water (after passing through sediment/carbon filters, and booster pump) enters RO #1. There are two outlets from RO #1 which I assume one is filtered water and the other is dirty water. The clean water is sent to ASO and then DI filters. The dirty water is routed to the inlet for RO #2.

I would have imagined that the system would be setup in 1 of 2 scenarios. Parallel or in series.

1. The source water is split between each RO membrane. The like outlets are combined and sent to waste and DI filters.
2. The source water is routed through RO #1. Dirty water to waste, clean water to RO #2. Outlets of RO #2 go to waste and DI filters.

Before moving the TDS probes around to check, I thought I would ask here to see if someone could help.

Thanks

 

[lapin]

They have video's

Water Saver Upgrade Kit

Why does BRS recommend this? Water Saving Upgrade Kits are probably our most recommended RODI upgrade. If you have proper pressure (65+ PSI) we highly recommend installing the kit, because it will produce water twice as fast as a standard 75 GPD or 100 GPD membrane while cutting the amount of...

www.bulkreefsupply.com

 

[Echomsp]

So my system is configured correctly, but it is not advised to use this configuration with high TDS source water. My source water reads between 500-600 TDS. I'll just have to experiment and see if I can lower my TDS readings.

I'm seeing 13.3 microsiemens after the DI filters.