setting a tank on side for drilling ??

[cracker]

This Afternoon , I'm about to drill a 180 and need it set on it's side. Ya think a couple of furniture dolly's will give enough support? placed at each end. Thanks

 

[cromag27 Verified Sponsor]

Lock the wheels and put a blanket over the dollies. if the tank doesn't have trim I'd even put painter's tape over the panels that will touch the dollies additional protection.

 

[cracker]

Hey Cromag, So The tank is on the dolly's and I got one hole drilled. the ends had a hard rubber covering I duct taped some card board over that for a softer place to sit. Worked out fine. I was over thinking this. It took me a good 20 to drill thru the glass. The bit has 4 holes with it so it's still good. The glass was 1/2 inch. Thanks for the reply !