Setting Power on Delays

[member 99594]

Hey all,

I recently had a power outage and my skimmer cup overflows when the power comes back on. I then realized that I should have delays on all of the equipment before coming back on. So, I have the following setup and it does not seem to be working.

I don't used feed schedules I just run very basic from what I think After plugging back in the power comes back on for everything and the ATO goes bananas and the skimmer overflows.

Water change process:
I really just use the sliders for ATO, ReturnPump and Skimmer and turn them off. When ready to turn the system back on I flip them all back on starting with ReturnPump then Skimmer then ATO

Any suggestions to make that easier would be helpful too.

Thank you in advance!!!



Skimmer:
Fallback OFF
Set ON
If Output ReturnPump = OFF Then OFF
Defer 005:00 Then ON

ATO:
Fallback OFF
Set ON
If Output ReturnPump = OFF Then OFF
Defer 005:00 Then ON

Refugium Light:
Fallback OFF
Set OFF
If Time 21:00 to 10:30 Then ON
If DT_TMP > 81.0 Then OFF
Min Time 001:00 Then OFF
If Output ReturnPump = OFF Then OFF
Defer 005:00 Then ON

Carbon Reactor:
Fallback OFF
Set ON
If Output ReturnPump = OFF Then OFF
Defer 005:00 Then ON

Doser:
Fallback OFF
Set ON
If Output ReturnPump = OFF Then OFF
Defer 005:00 Then ON

ReturnPump:
Fallback ON
Set ON
If FeedB 000 Then OFF

 

[SuncrestReef]

I answered your question in the Neptune Community Forum:

Help! After power outage programming

Hey all, I recently had a power outage and my skimmer cup overflows when the power comes back on. I then realized that I should have delays on all of the equipment before coming back on. So, I have the following setup and it does not seem to be working. I don't used feed schedules I just...

forum.neptunesystems.com