Sfin's Dream.

Lost in the Sauce · May 4, 2022

sfin52 said:
I think most of these pumps are designed to run the length not the width of the tank.

I think they're just designed to move water in a laminar sheet. If this was an SPS tank, It wouldn't be enough flow. Given that it is LPS dominated, it's too much for the intended use.

dvgyfresh · May 4, 2022

Lost in the Sauce said:
I think they're just designed to move water in a laminar sheet. If this was an SPS tank, It wouldn't be enough flow. Given that it is LPS dominated, it's too much for the intended use.

I have the same gyre for length of my 75/80 and it’s on lowest and I think it’s too much haha need to get another on other side to offset it

sfin52 · May 4, 2022

dvgyfresh said:
I have the same gyre for length of my 75/80 and it’s on lowest and I think it’s too much haha need to get another on other side to offset it

So the jebao cp 90 seems too much for a 75/90. That helps a lot thanks

sfin52 · May 4, 2022

Jebao ow-25 is a very real contender.

dvgyfresh · May 4, 2022

sfin52 said:
So the jebao cp 90 seems too much for a 75/90. That helps a lot thanks

Yea alone I think it’s too much , it needs another wave maker on opposite going against it to weaken flow / disrupt. Sadly I can’t make my return pump higher otherwise it becomes too noisy , I’ll probly pair it with the ow-25

sfin52 · May 4, 2022

dvgyfresh said:
Yea alone I think it’s too much , it needs another wave maker on opposite going against it to weaken flow / disrupt. Sadly I can’t make my return pump higher otherwise it becomes too noisy , I’ll probly pair it with the ow-25

I get that.