SPS reaction to UV
- Thread starter SaracensRugby
- Start date
- Tagged users None
Canadareefer666
New Member
Just for clarification, are you talking about UV sterilizer or UV spectrum with your LED lights like Radions have?
Canadareefer666
New Member
weird. Any thing else changed at all. I just can't see the UV having that kind of effect that quickly.
Long shot idea, have you checked for electrical leakage?
Would also say that since the uv bulb and ballast are not touching water, and with it being a new unit salt creep not a conductor, that stray voltage from the uv probably not the issue.
Maybe the uv and/or additional pump to supply it raised your tank temp
Maybe the uv and/or additional pump to supply it raised your tank temp
Steven Garland
Valuable Member
Almost looks like feeding filaments to me,but I have not the slightest.
Foothill Corals
Active Member
Fresh pvc glue or stray voltage?
Are you running a gfci and a ground probe?
Are you running a gfci and a ground probe?
AcanthurusRex
Well-Known Member
Please explain the physics behind this assessment.
OP
OP
SaracensRugby
Active Member
Fresh PVC glue on the plumbing so yes there; fresh being 3 days old anyway. Yes on GFCI I believe, my Apex is hooked up to one of those expensive Triplite surge protectors. And it kept tripping every time my heater went on. So took UV off my apex (which was plugged into triplite). I tried one of those grounding probes years ago, and my clowns started acting very erratic and jerky. Took the probe out, clowns back to normal. I have gone down the rabbit hole with the grounding probes reading different "electricians" argue that on here, but my N of 1 has me wary of that option unfortunately.
Foothill Corals
Active Member
Ground probes are good if on a ground fault circuit (gfci) I don’t think any of the Triplite stuff includes gfci it’s not the same as a surge protector.
I would get a gfci installed (if you don’t have actually one) and also check for stray voltage. Three day old glue is not a problem.
I would get a gfci installed (if you don’t have actually one) and also check for stray voltage. Three day old glue is not a problem.
Yup
Gfci paired with a ground probe is the only way to go, and then you won’t have to check for stray voltage because you will know likity split.
If you put a ground probe without a gfci you’re only completing the circuit
Gfci paired with a ground probe is the only way to go, and then you won’t have to check for stray voltage because you will know likity split.
If you put a ground probe without a gfci you’re only completing the circuit
BTW, if you don't want to install a GFCI at the wall socket, you can buy external ones. I bought a heavy duty one on amazon that I run my system through. Cheap and easy to install.. just make sure the one you buy has default state of ON and not OFF.
I don't think you need to worry about your colony. The filaments don't seem unnatural to me, although agree it would feel a bit concerning. If you haven't changed anything other than adding the UV, it's possible it's just a slight irritation to the dry PVC glue or maybe a coincidental response. If doesn't change after 2ish days, then time to reevaluate.
I don't think you need to worry about your colony. The filaments don't seem unnatural to me, although agree it would feel a bit concerning. If you haven't changed anything other than adding the UV, it's possible it's just a slight irritation to the dry PVC glue or maybe a coincidental response. If doesn't change after 2ish days, then time to reevaluate.
