Sunrise/Sunset and Sliding Clouds with Mitras 7206's

[*Ruffian*]

Hi all,

Looking for some guidance on getting the sunrise sunset along with sliding clouds working on the Profilux. I have a P4 with the PWC card and 3 7206's. The PWC card is id 1 and the lights are 2-4.

I have the clouds working but not sliding. I see the timeshift and cloud delay in GCC. Reading the programming documentation, I think I have to send my illumination run with the delays to each light? Not sure if I am on the right track and how do you do that with the PWC card?

Thanks in advance.

Steve

 

[BeanAnimal]

Just ordered 2x 7206 - can anybody jump in here with some basic instructions?

 

[Vinny@GHLUSA Verified Sponsor]

Just ordered 2x 7206 - can anybody jump in here with some basic instructions?

Since the P4 will be controlling these lights, light schedule and simulation related settings are done on the ProfiLux Illumination section. For sunrise/sunset, you would create your own light schedule and make the 2nd time point the start of your sunrise effect. 3rd time point would be the end, then 4th point would be your "daytime" spectrum.

The sunset effect is done in a similar way except this one is added near the end of your light schedule.

You'll find cloud effect options in the Simulation page of the Illumination section. Page 9 (Section 2.3) of the Mitras LX7 manual explains how this simulation works. If you want to create a sweeping effect, read 2.3.2 as this applies to the ProfiLux (Master device) and 2.3.1 for the lights themselves.

 

[BeanAnimal]

Thanks will give it a go when the lights arrive!

 

[Vinny@GHLUSA Verified Sponsor]

Thanks will give it a go when the lights arrive!

Follow these steps to control the LX7s via the ProfiLux:

How to control Mitras LX7 via ProfiLux - GHL Advanced Technology

www.aquariumcomputer.com