The Mediocreef

Mschmidt · May 19, 2023

Numbered today.

MrsBugmaster · May 19, 2023

Mschmidt said:
Numbered today.

I would of expected the phosphate number to be higher with that high of nitrates

Mschmidt · May 19, 2023

MrsBugmaster said:
I would of expected the phosphate number to be higher with that high of nitrates

Maybe that's why I have ***** gonis. I may try to bring n down. Also gotta get the alk under control. Always low.

tbrown · May 19, 2023

MrsBugmaster said:
I would of expected the phosphate number to be higher with that high of nitrates

My phosphates bottom out when my nitrates get high. I'm running 50ish nitrates and dosing 10 ml of NeoPhos a day in a 125 to keep detectable phosphates. Usually less than 0.05.

Mschmidt · May 23, 2023

Busy weekend. Parent's were in town so my dad and I made a Murphy bed.

I made it, so now I have to lay in it?

Projects with Sam · May 23, 2023

Mschmidt said:
Busy weekend. Parent's were in town so my dad and I made a Murphy bed.

I made it, so now I have to lay in it?

looks awesome! but.... less room for fishy tanks!

tbrown · May 23, 2023

Projects with Sam said:
looks awesome! but.... less room for fishy tanks!

His next project is a Murphy tank.

Mschmidt · May 23, 2023

Projects with Sam said:
looks awesome! but.... less room for fishy tanks!

Space hasn't changed. Now it's not a mattress on the wall in the guest room.
Edit: I did make sure there was room for the tank though. It is after all my office, has to have a tank.

tbrown3589 said:
His next project is a Murphy tank.

rmorris_14 · May 23, 2023

Mschmidt said:
Busy weekend. Parent's were in town so my dad and I made a Murphy bed.

I made it, so now I have to lay in it?

I'm throughly disappointed the picture you posted wasn't with you posing on it.

Mschmidt · May 23, 2023

rmorris_14 said:
I'm throughly disappointed the picture you posted wasn't with you posing on it.

That's on the wife's camera.

Mschmidt · May 23, 2023

On a marginally more serious note, my lights (used kessil 360s) started fading in and out this weekend. I think it is related to the controller as that seems to start it. But without the, controller, the lights should just revert to their settings on the dials right?

We were running saws, on an outlet that may be the same circuit but that should only matter when we were using them, not after the fact.