The Mediocreef

[Mschmidt]

I could be wrong though. It just looks like a clogged nozzle or eSteps.

Could be estep. Is usually not an issue though. But I did change the line width to .5.

 

[stoney7713]

It extruded fine when it wasn't printing. That was the first thing I looked at.

Petg, 240 no cooling. I can crank it, but should be ok there.

It was after a few tpu prints, that may have caused some sticking. Not sure.

Got the same thing going now with pla, 200 maybe cooling, didn't look. And it's fine.

Ohhhhh yes TPU causes prints to mess up. Its gummy and sticks in the nozzle. Takes forever to clean out. TPU is interesting and I like to use it for things but the clean up is awful and I have troubles for a few prints afterwards.

I use this through the top swirl it around over and over to clean it out.

 

[Mschmidt]

Grr again!
Adhesion this time.

 

[Mschmidt]

Ohhhhh yes TPU causes prints to mess up. Its gummy and sticks in the nozzle. Takes forever to clean out. TPU is interesting and I like to use it for things but the clean up is awful and I have troubles for a few prints afterwards.

I use this through the top swirl it around over and over to clean it out.

Made some teethers from tpu, now a random flow generator. I'll dig around for some way to clean up after. Also would probably help to take it out right after, not reheat everything to remove it.

 

[stoney7713]

Made some teethers from tpu, now a random flow generator. I'll dig around for some way to clean up after. Also would probably help to take it out right after, not reheat everything to remove it.

It sticks bad, worse than removing molten hot glue from your finger tips.

 

[Mschmidt]

It sticks bad, worse than removing molten hot glue from your finger tips.

Give it it's own printer...

 

[stoney7713]

Give it it's own printer...

Or if you had the quick change nozzles like on the A1

 

[stoney7713]

Another printer is above my pay grade still, soon though...

 

[Projects with Sam]

I vote replace the nozzle if you're running typical brass nozzle. If hardened it should last a little longer... may be the tpu like you commented

 

[Mschmidt]

Or if you had the quick change nozzles like on the A1

Another point for the prusa.

Another printer is above my pay grade still, soon though...

Not even soon here. Maybe get the ender running and that can be the tpu printer.

 

[Mschmidt]

I vote replace the nozzle if you're running typical brass nozzle. If hardened it should last a little longer... may be the tpu like you commented

If problems come this print I might do that.

 

[Mschmidt]

2 days of gfo.

Also a water change.

And scraped.

 

[tbrown]

HAPPY BIRTHDAY MARSHALL!!!!!!!

 

[danieyella]

Happy Birthday!!

 

[Stang67]

 

[stoney7713]

 

[rmorris_14]

 

[Mschmidt]

Thank you all! It was a good day, except the poopy diaper that I had to change.
We went to the aquarium! He was more excited than I was.

 

[MrsBugmaster]

Happy Belated Birthday.

 

[Mschmidt]

Thanks @AVAST Marine @Avast Justin for the participation trophy!