This looks like aiptasia right?

[SeZMehK]

Sorry for the dirty glass. I have to stick my hand in the tank to scrap it off. When this frag fell down, I noticed something. This looks like aiptasia doesn't it? This was a frag from WWC that I got. I always thought it was GHA since I have a small problem with that. Any solutions other than aiptasia-x? It. Currently is only on this frag just under the coral. Oh, this frag is a jason fox slow Burn monti. On a side note, where can I place that coral?

 

[X-37B]

Yep

 

[Wolf89]

Thats a few good sized aiptasia. I'd probably glue them over or chuck the coral

 

[Malifry97]

Yeah I’d take it out and super glue all over them, WHILE OUT OF THE WATER SO THEY DONT SPLIT WHILE AGGITATED

 

[SeZMehK]

I was hoping it wasn't. It's going to be hard to use superglue on it because it looks like it is attached to the coral and not the plug. I'll give it a shot once I find my super glue.

 

[Evan28395950]

Also could use aiptasia-x, thought it may take a few applications to kill it

 

[Terri Caton]

Also could use aiptasia-x, thought it may take a few applications to kill it

+1

 

[DSC reef]

Remove the plug from the tank and remove the coral from the plug, throw the plug away. The montipora is encrusting so you can glue it to another rock or even the bottom of the tank. I would not treat aptasia in the tank if it doesn't have to be.