Trident FAQ (official)
- Thread starter Terence
- Start date
- Tagged users None
Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)
jphilip813
Well-Known Member
Question, I just got mine last night from my LFS...Does the Trident have the ability to automatically log the test results? Where do I go to enable that feature?sent the ever so frusterating turd of a reefbot back to reef kinetics and got a trident with my refund! never been happier!!
yes it logs every test. click on the trident icons that look like scientific beakers etc. 1st click will bring up your graph with chartes test results and if you click a 3rd time it will then show you the % of reagents remaining
jphilip813
Well-Known Member
Thx for the reply. I saw that option. I was actually referring to the Log used by the Test Kits...There is a log that is generated once you either input it manually or use Alexa to input it for you and it stays there until you remove it.
jphilip813
Well-Known Member
WAIT...I see what you were referring too....The Log i screen captured is for "Test Kit" Logs, whereas Trident keeps it own....Thanks again.Thx for the reply. I saw that option. I was actually referring to the Log used by the Test Kits...There is a log that is generated once you either input it manually or use Alexa to input it for you and it stays there until you remove it.
I have a couple questions about the hoses (intake/waste). How long are both of them? Are they easy to kink/pinch? If so they look pretty small like they might fit inside a 1/4" push connect to protect them? I think I saw the drain line can't be extended either (I get why the intake can't be). I have a drain nearby but it's 5-6 feet away, I don't see why I couldn't "extend" the waste line with a much larger line/pipe sloping to drain. That wouldn't be any different that dumping in a container.
ca1ore
10K Club member
Excellence Award
Reef Tank 365
CTARS Member
Article Contributor
R2R TV Featured
You can ‘extend’ the drain line by directing it to a larger hose as long as an ‘air gap’ persists .... that’s what I’m doing.
ca1ore
10K Club member
Excellence Award
Reef Tank 365
CTARS Member
Article Contributor
R2R TV Featured
Doesn’t seem like Neptune is monitoring this thread anymore, but just in case they are ....
Any new information in the health check for trident? Mine is now almost 6 months old and I seem to recall that a health check was recommended at a year. Is that still the case? What will be the procedure? Thx.
Any new information in the health check for trident? Mine is now almost 6 months old and I seem to recall that a health check was recommended at a year. Is that still the case? What will be the procedure? Thx.
U
User1
Guest
Just got back my ATI ICP test. Trident seems to be doing well. Interesting enough I was running low with my B and C reagents which I think was causing my CA to report high. I've since replaced those reagents and CA reported 431 during the test this morning which is close to what ATI reported.
Pretty neat. I've also run a manual ALK test using my Hanna checker and it is inline with the numbers below. Super awesome sauce product. Glad I picked one up.
This mornings results:
Pretty neat. I've also run a manual ALK test using my Hanna checker and it is inline with the numbers below. Super awesome sauce product. Glad I picked one up.
This mornings results:
jlts21
Well-Known Member
I started my own thread on my issue, but thought I would post this here as well.
"Has anybody else noticed or read about an potential issue with the Trident testing? I run my tank on the higher side (alk 10, cal 465, mg 1500) and I have noticed that at noon my cal is 468 and at midnight it is 486. It has been like this for the past week (was set up November 18th). I have not been dosing for the past 1-1.5 weeks so I am not sure what is going on. I manually tested before setting up and everything was spot on so I continued dosing manually and was going to wait to set up automatic dosing until I knew the Trident was consistent and accurate. If I am not dosing, I do not understand why the cal would be fluctuating that much while alk has steady and very slowly been declining (was 9.95 dkh on 11/29 and is now 9.15)"
"I am doing the minimum testing (4,2,2). No lights/light spill at night (midnight) as lights go off at 8:30. Trident is on an end table next to my tank so the only light spill, if any, would be during the day. But it sits quite a bit lower that the tank so I don't think there is any light spill to it. I didn't think about that being a potential issue so I'm glad you brought that up. I decided to place it where it is so that I don't have to climb underneath the tank to change out reagants."
Mag has slowly been increasing as well without dosing anything for the past 1-1.5 weeks
"Has anybody else noticed or read about an potential issue with the Trident testing? I run my tank on the higher side (alk 10, cal 465, mg 1500) and I have noticed that at noon my cal is 468 and at midnight it is 486. It has been like this for the past week (was set up November 18th). I have not been dosing for the past 1-1.5 weeks so I am not sure what is going on. I manually tested before setting up and everything was spot on so I continued dosing manually and was going to wait to set up automatic dosing until I knew the Trident was consistent and accurate. If I am not dosing, I do not understand why the cal would be fluctuating that much while alk has steady and very slowly been declining (was 9.95 dkh on 11/29 and is now 9.15)"
"I am doing the minimum testing (4,2,2). No lights/light spill at night (midnight) as lights go off at 8:30. Trident is on an end table next to my tank so the only light spill, if any, would be during the day. But it sits quite a bit lower that the tank so I don't think there is any light spill to it. I didn't think about that being a potential issue so I'm glad you brought that up. I decided to place it where it is so that I don't have to climb underneath the tank to change out reagants."
Mag has slowly been increasing as well without dosing anything for the past 1-1.5 weeks
Kyl
And how does it feel like, to wake up in the sun
This seems to be making the rounds. One-off, or is this going to be every time?
Get Started | Modified Trident Reagent Replacement
Modified Trident Reagent Replacement: Preface If you have been directed to this page, due to the card found in your reagent kit, it is because the Trident will need a slightly modified reagent replacement method to achieve the most precise and accurate measurements. The entire reagent...
www.neptunesystems.com
U
User1
Guest
This seems to be making the rounds. One-off, or is this going to be every time?
Get Started | Modified Trident Reagent Replacement
Modified Trident Reagent Replacement: Preface If you have been directed to this page, due to the card found in your reagent kit, it is because the Trident will need a slightly modified reagent replacement method to achieve the most precise and accurate measurements. The entire reagent...www.neptunesystems.com
It is a note that comes with the reagents. At least that is where I got mine from when I opened the box.
Mr4000
Community Member
This is how i program my trident for my Calcium reactor
Fallback OFF
Set OFF
If Alkx3 < 9.30 Then ON
If Alkx3 > 9.35 Then OFF
It keeps my alk and cal very stable. My reactor is a Deltec Twin tech 1500. Its electronic controlled so i don't know if this will work with a regular reactor. Keeps my ph higher also as the reactor is not running all the time.
Fallback OFF
Set OFF
If Alkx3 < 9.30 Then ON
If Alkx3 > 9.35 Then OFF
It keeps my alk and cal very stable. My reactor is a Deltec Twin tech 1500. Its electronic controlled so i don't know if this will work with a regular reactor. Keeps my ph higher also as the reactor is not running all the time.
psionicdragon
Active Member
Thanks Mr4000!
Do you have the recirc pump off too? Can you elaborate on the "electronic controlled"?
JCOLE
Grower of the Small Polyps
I started a new thread but figured I would post this here as well. Any help would be greatly appreciated.
Hello everyone! I have had my Trident up and running for a couple of months and love it. However, it always seems that my B and C reagents run out before my reagent A. I am running the minimum test of 4x a day. See below. It is showing Reagent C is low with about 30 more tests on Alkalinity(Reagent A). It will not allow me to run any manual Alk tests like this. I was thinking of just resetting the Reagent C but I don't want to run the risk of messing up the trident if this isn't recommended.
Hello everyone! I have had my Trident up and running for a couple of months and love it. However, it always seems that my B and C reagents run out before my reagent A. I am running the minimum test of 4x a day. See below. It is showing Reagent C is low with about 30 more tests on Alkalinity(Reagent A). It will not allow me to run any manual Alk tests like this. I was thinking of just resetting the Reagent C but I don't want to run the risk of messing up the trident if this isn't recommended.
I started a new thread but figured I would post this here as well. Any help would be greatly appreciated.
Hello everyone! I have had my Trident up and running for a couple of months and love it. However, it always seems that my B and C reagents run out before my reagent A. I am running the minimum test of 4x a day. See below. It is showing Reagent C is low with about 30 more tests on Alkalinity(Reagent A). It will not allow me to run any manual Alk tests like this. I was thinking of just resetting the Reagent C but I don't want to run the risk of messing up the trident if this isn't recommended.
Sure you can reset B and C. But note that it will result in sucking air and getting bad results at some point.
