Uniclife DEP-4000 Controllable DC Water Pump 1052 GPH help??

[jaxteller007]

I got this the other day to run our UV sterilizer. I know, I know it's off brand. But i couldn't afford to buy a super expensive one right now and needed to get the UV running. It seems to be running correctly but I have no idea how to read the display on the controller to estimate gph. If i hit the power increase button till it goes to 100, the display shows P 35. Lower the power setting to what I assume is 90% (where I think i need to be) and the display reads P 30, and so on. Any one got any ideas?


#reefsquad

 

[Ron Reefman]

Didn't the instructions explain it?

So the display goes from 100 down to 0. I'd assume 90 is 90%. I have no idea what the P # means.

 

[jaxteller007]

Didn't the instructions explain it?

So the display goes from 100 down to 0. I'd assume 90 is 90%. I have no idea what the P # means.

Not at all lol. Instructions were very very basic. Best I can figure from googling is the P is power being used like how many watts