Using 2 sensors to fill topoff

[chrispol]

I am trying to figure out a way to use 2 float sensors(low/high) to fill a top-off container.

When the lower sensor is triggered turn on an outlet, and turn off the outlet when the top float is triggered.

I tried this using an ato as Oneshot running a macro, but it just seems to hang.

Any ideas?

 

[Buckeye Hydro Verified Sponsor]

You are describing our Hi-Low Controller

Hi - Lo Tank Level Controller

At Buckeye Hydro we specialize in providing the highest quality water filtration systems and accessories for every potential need.

www.buckeyehydro.com

Russ

 

[Buckeye Hydro Verified Sponsor]

dupe

 

[robsworld78]

Take a look at this post, it shows how to setup reef-pi, ignore the hardware as it's all the same.

Setting float

 

[chrispol]

That would be a bit outside the point of using the reef-pi....

I have an ATO setup for the low-level one-shot to launch a macro, that turns on the rodi pump, turns off the low-level ato, and turns on the high-level ato.

Then the high-level is a one-shot that launches a macro to turn off the high-level, turn on the low-level and turn off the rodi pump.

 

[GuppyHJD]

Chris
Look at Autotopoff.com